5 
6. Place new belt around motor shaft.
6
7
7.Place belt around brush roll pulley.
8.Pull right side of brush roll to stretch belt. Secure right end cap into base.
8
Left side view
9.Align left end cap with square in base. Push end cap into place; see left side view.
9
10.Rotate brush roll to seat belt.
11.Replace the hood. Make sure hood front is behind furniture guard.
12.Tighten screws.
Use GE brand replacement belt, Style
To Change Dust Cup Foam Filter:
NOTE: Turn off the switch and unplug the electrical cord before changing the Foam Filter. Never operate the vacuum cleaner without the dust cup or the foam filter assembly.
1
Dust Cup
Latch
2
Dust Cup
Release dust cup by rotating dust cup latch to the left pointing to the unlock symbol ( 
). Pivot dust cup out and away from cleaner and remove.
Remove cyclonic dust cup by pulling latch (1) forward, pivoting cyclonic dust cup out and lifting up. To replace cyclonic dust cup, put bottom of cyclonic dust cup in place by aligning tabs in slots and pivot top assembly back into place. Push down on latch (1), making certain that latch securely snaps and overlaps tabs at top of dust cup.
To maintain good performance, check and clean the Foam Filter each time the dust cup is emptied and clean if needed. The filter can be cleaned by washing with mild detergent and warm water. Be sure foam filter is completely dry before reinstalling.
11