GE 106585, 71415 warranty How To Assemble, Step a Remove Dust Cup, Step B Attach Handle

Page 4

How To Assemble

CAUTION: Assemble the cleaner completely before plugging into an electrical outlet.

CAUTION: Moving parts, stay clear of brush roll when plugging in.

NOTE: Features may vary by model yet all parts assemble the same.

Step A Remove Dust Cup

Dust

Cup

Latch

Dust Cup

Handle

Two Screw Locations

Step B Attach Handle

Handle

Tabs

Slots

Screw

Screw

Dust Cup

1.Remove dust cup from unit to expose the two screw installation locations. Release the dust cup by rotating the dust cup latch to the left. Pull out and up on the dust cup handle to remove from unit.

2.Position handle as above. Slide the handle down over the top of the unit, inserting handle tabs into slots on unit.

3.Find the two screws in the accessory bag included in the carton. To secure the handle on the unit, install the two screws.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Owner’s Guide Model Vacuum Cleaner Safety Important SafeguardsGeneral Information Customer AssistanceRating Plate Thermal Cut OffStep a Remove Dust Cup How To AssembleStep B Attach Handle Step C Replace Dust Cup Step D Store AccessoriesStep E Store Electrical Cord How To Use Suddenly turns off, follow this procedure Thermal Cut OffHow To Use Accessories How to Check and Clear Hose Blockages How To Maintain How To Replace Brush Roll Belt Style GE-1Brush Roll Brush Roll BeltTo Change Dust Cup Foam Filter Reinstalling the Cyclonic Dust Cup To clean the Foam FilterEmptying the Cyclonic Dust Cup Hepa Filter Cleaning and Replacing FiltersTo Replace Hepa Filter How To Change Light Bulb Problem Solving Problem Cause SolutionPage Two-Year Limited Warranty Customer AssistanceQuestions? Call Accessory Items in This Carton Authorized Appliance Parts
Top Page Image Contents