Installation Instructions
230/208 VOLT ELECTRICAL CONNECTION OPTIONS
HOW TO CONNECT
1Remove the room cabinet.
2Connect to electrical power.
3Review the following steps for applicable supply voltages.
4Reinstall the room cabinet.
Power cords may include an arc fault interruption or a leakage current detection interruption device. A test and reset button is provided on the plug case or the inline case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button. If the TEST button does not trip or if the RESET button will not stay engaged, discontinue use of the Zoneline and contact a qualified service technician.
POWER CORD
CONNECTION
A power supply kit must be used to supply power to the Zoneline unit. The appropriate kit is determined by the voltage, the means of electrical connection and the amperage of the branch circuit.
Power supply kit
Connections of 208 or
All wiring, including installation of the receptacle, must be in accordance with the NEC and local codes, ordinances and regulations. Local codes may require the use of an arc fault or leakage current detection device on the power cord. Be sure to select the correct cord for your installation.
Tandem | Perpendicular | Large Tandem | |||
15 Amp. | 20 Amp. |
| 30 Amp. | ||
|
|
|
| ||
Branch Circuit and |
| Proper GE Power Cord | |||
Unit Amperage Rating |
|
| with LCDI Device | ||
|
|
|
|
|
|
| 15 |
|
| RAK3153 | |
|
|
|
|
|
|
| 20 |
|
| RAK3203 | |
|
|
|
|
|
|
| 30 |
|
| RAK3303* | |
|
|
|
|
|
|
*Not approved for use on 7000 BTU models.
ELECTRICAL SUBBASE CONNECTION
Branch Circuit and | Proper GE | |
Unit Amperage Rating | Subbase Kit | |
|
|
|
15 | RAK204D15P | |
|
|
|
20 | RAK204D20P | |
|
|
|
30 | RAK204D30P* | |
|
|
|
*Not approved for use on 7000 BTU models.
Electrical subbases provide an enclosure for direct connection or enclosed receptacles. The subbase kit includes the power cord.
The instructions provided with the selected subbase kit must be carefully followed. It is the responsibility of the installer to ensure the connection of components is done in accordance with these instructions and all electrical codes.
DIRECT CONNECTION
Order the following Kit for
Branch Circuit and | Power Supply | Power | |
Unit Amperage Rating | Accessory | Supply Kit | |
|
|
|
|
15 | RAK4002A | RAK4157 | |
|
|
|
|
20 | RAK4002A | RAK4207 | |
|
|
|
|
30 | RAK4002A | RAK4307 | |
|
|
|
|
Skip to the “MAKE ELECTRICAL CONNECTION TO THE UNIT” section.
13