Before you call for service… | ge.com | ||
|
|
|
|
Problem | Possible Causes | What To Do | |
|
|
|
|
The air is not always | The heat pump is not | • This is normal. The heat pump will produce warm air | |
cool or hot during | producing hot air. | but not as hot as air produced when the | |
operation |
|
| electric heat is used. |
|
|
|
|
| The fan switches may be | • This causes the fan to blow room temperature air | |
| set at continuous fan. | even when the compressor or heater cycles off. | |
|
|
| The continuous air movement provides better |
|
|
| overall temperature control in the cool mode. |
|
|
| • There is one switch for cooling and one switch |
|
|
| for heating. |
|
|
| |
The air does not feel | The heat pump alone | • Use the Electric Heat Option. This turns off the | |
warm enough during | produces air that feels | heat pump and warms with electric heat only. | |
heating operation | cooler than desired. | NOTE: Use of this option will result in increased energy | |
|
|
| consumption. |
|
|
| |
The unit is not | The fan dip switch may | • See the Auxiliary Controls section. | |
blowing out air | be set to CYCLE. |
| |
|
|
| |
The electric heating | The power cord is not | • Remove the room cabinet and make sure that the | |
feature does not work | firmly attached. | yellow connector on the end of the power cord is | |
|
|
| firmly engaged. |
|
|
| |
Temperature display | The compressor may | • Set the operation control to STOP and then restart | |
flashes | have failed. | the unit. If the flashing light reappears within | |
|
|
| 30 minutes, call for service. |
|
|
| |
21
Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting Tips