Wired Remote Controller-Buttons and Display
To use the wired remote controller, refer to an appropriate manual.
| Operating mode | |
| Centralized controller indicator | |
Removing frost indicator | (In case of installing the Centralized controller) | |
Communication |
| |
error indicator |
| |
On Timer setting | Temperature setting | |
Fan speed | ||
Off Timer setting | Air flow direction | |
Test indicator | Filter Sign indicator | |
| On/Off button | |
Temperature adjustment | On/Off indicator | |
buttons | ||
Fan speed | ||
On Timer button | ||
| adjustment button | |
Timer Set/Cancel button | Swing button | |
| (Not operated) | |
Test button | Filter Reset button | |
| Mode selection button |
Note | ◆ The | button is for your installation specialist. You must NOT press it. | |||
| ◆ After cleaning the air filter, press the | button. Then the wired remote | |||
| controller will display the FILTER SIGN indicator when the time to clean the air filter; | ||||
| refer to page 13. |
|
|
| |
| ◆ Duct type air conditioner does not have function of adjusting air flow direction. | ||||
| Therefore, the function is not operated even if you press the |
| button. | ||
|
| ||||