Removing Excess Humidity
If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. You can operate the Dry mode only by using the control panel.
Remote Control | Control Panel | 1 If necessary, press the |
| (On/Off) button. | ||||
| ||||||||
|
|
|
|
|
| |||
|
|
|
|
| Result: | ◆ The air conditioner starts up in the mode selected when | ||
|
|
|
|
| ||||
|
|
|
|
|
| the unit was last used. | ||
|
|
|
|
|
| |||
|
|
|
|
| ☛ | ◆ The unit beeps. | ||
|
|
|
|
| ||||
|
|
|
|
| The air conditioner is fitted with a protection mechanism to | |||
|
|
|
|
|
| prevent the unit from being damaged when it is started | ||
|
|
|
|
|
| |||
|
|
|
|
|
| immediately after being: | ||
◆Plugged in
◆Stopped
It will start up normally after three minutes.
2 If the “ | ”indicator is not displayed at the top of the control panel, | ||
press the |
| button on the control panel one or more times until it | |
appears. |
|
|
|
Result: | ◆ The unit beeps each time you press the | button. | |
| ◆ The air conditioner runs in Dry mode. |
| |
➢ | You can change modes at any time. |
| |
| The “ | ” passes through the control panel. |
|
3 To adjust the temperature, press the 
or 
buttons one or more times until the required temperature is displayed.
Possible temperatures are between 64°F and 86°F inclusive.
Result: ◆ Each time you press the 
or 
buttons: - The temperature is adjusted by 1°F
- The unit beeps
◆The air conditioner starts removing the excess humidity; the quantity of air is adjusted automatically.
4To control the direction of the air flow, refer to page 11.