Cooling Your Room
You must select the COOL mode if you wish to adjust the : ◆ Cooling temperature
◆ Fan speed when cooling
1 If necessary, press (ON/OFF) button.
Result: ◆ The On/Off indicator on the wired remote controller comes on.
◆ The air conditioner runs in the mode selected when ◆ the unit was last used.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆ Stopped
lt will start up normally after three minutes.
2 To select the COOL mode, press the Mode button until | is displayed at | |
the top of the wired remote controller. |
| |
Result: | ◆ The air conditioner runs in COOL mode. |
|
Note | You can change modes at any time. |
|
3 To adjust the temperature, press the Temperature buttons one or more times until the required temperature is displayed. Possible temperatures are between 65OF and 86OF inclusive.
Result: ◆ Each time you press Temperature buttons: - The temperature is adjusted by 1OF.
◆ The air conditioner starts cooling, provided that the room
◆ temperature is higher than the selected temperature ; the fan
◆will, however, operate.
4Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
Automatic(rotated : ➔ ➔ )
Low
Medium
High
5To control the direction of the air flow, refer to page 17.