Cassette tape
Top of unit
Disc lid |
| CD OPEN/CLOSE 0 |
Basic play | Recording the radio |
1 Press [0] and insert the cassette. | 1 Insert the cassette to be recorded. |
ENGLISH
English
| Forward side | Insert inside the guides |
2 | Close the lid by hand. |
|
3 | Press [TAPE 3] to start play. |
|
To play the other side of the cassette, turn the cassette over.
To | Action |
stop tape playback | Press [ 7 ]. |
|
|
start | Press [TAPE 3] when the unit is OFF with |
| the cassette loaded. |
|
|
Press [ /REW/4] or [ /FF/¢] in the | |
rewind | stop mode. |
|
|
Note
•Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.
•Endless tapes can get caught up in the deck’s moving parts if used incorrectly.
TPS (Tape Program Sensor)
2 | Tune to the required station (refer to page 10). |
3 | Press [¶ REC/8] to start recording. |
Recording discs | |
1 | Insert the cassette to be recorded. |
2 | Push [CD OPEN/CLOSE 0] to insert the disc and |
| close the lid. |
3 | Press [CD 3/8] and then [7, |
4 | Press [PLAY MODE] to select your desired mode |
| (refer to page 7). |
5 | Press [¶ REC/8] to start recording. |
Recording programmed tracks | |
1 | Insert the cassette to be recorded. |
2 | Program the tracks you want (refer to page 8). |
3 | Press [¶ REC/8] to start recording. |
Other basic operations
English
This function enables you to search the beginning of a track, up to a maximum of 9.
Press [/REW/4] or [/FF/¢] during play.
Play resumes from the track found.
Note
TPS may not function properly:
•with short silent parts
•when noise occurs between tunes
•if silent parts are found within tunes
Recording
To | Action | |
erase a recorded | 1) | Insert the cassette to be recorded. |
sound | 2) | Press [TAPE 3] and then [7, |
| 3) | Press [¶ REC/8]. |
|
| |
stop recording | Press [ 7 ]. | |
|
|
|
stop recording | 1) | Press [¶ REC/8]. |
temporarily | 2) | Press again to resume recording. |
|
| |
record on the other | Turn the cassette over and press | |
side of the tape | [¶ REC/8]. | |
|
|
|
Use normal position tapes. | Erasure prevention |
| |
|
|
| |
High position and metal position tapes can be used, but this | The illustration shows how to remove the tabs to prevent | ||
unit will not be able to record or erase them correctly. | recording. To record on the tape again, cover as shown. | ||
Preparation |
|
| To |
Wind the leader tape so that recording can begin |
| Side A | Normal tape |
immediately. |
|
|
|
| Tab for side B | Tab for side A | Adhesive tape |
|
|
|
RQTV0080
9