Vent Control, Air Direction Side-to-Side

SafetyInstructions

About the controls on the air conditioner.

Additional controls and important information.

Energy Saver (on some models)

The energy saver switch controls the fan.

ON —The fan and compressor cycle on and off together. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied.

OFF — The fan runs all the time, while the compressor cycles on and off.

This switch must be set at OFF in order to use the fan settings (on the mode control).

TroubleshootingTips InstallationInstructions Operating Instructions

CustomerService

Vent Control

The vent control is located above the control knobs.

When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.

			To open the vent, pull the lever toward you.
			To close it, push it in.

Air Direction – Side-to-Side
On some models, the side-to-side air direction is			CIRCULAIRE (on some models)
adjusted by moving the lever to the left or right.			For fixed side-to-side air direction, set the
			For fixed side-to-side air direction, set the
			Circulaire switch to ON until the desired air
			direction is obtained, then move it to OFF.
			For continuous side-to-side air circulation (cool
			settings only), set the Circulaire switch to ON.

Air Direction – Up and Down

Fingertip pressure on the horizontal louvers adjusts the air direction up or down.