GE AGM24 operating instructions Troubleshooting tips

Troubleshooting tips. ge.com

Troubleshooting Tips.

Save time and money! Review the chart below first and you may not need to call for service.

Problem	Possible Causes	What To Do
Air conditioner	The air conditioner	• Make sure the air conditioner plug is pushed completely
does not start	is unplugged.	into the outlet.
	The fuse is blown/circuit	• Check the house fuse/circuit breaker box and replace
	breaker is tripped.	the fuse or reset the breaker.
	Power failure.	• The unit will automatically re-start in the settings last
		used after the power is restored.
		• There is a protective time delay (approximately
		3 minutes) to prevent tripping of the compressor
		overload. For this reason, the unit may not start
		normal cooling for 3 minutes after it is turned
		back on.
	The current interrupter	• Press the RESET button located on the power cord plug.
	device is tripped.	• If the RESET button will not stay engaged, discontinue
		use of the air conditioner and contact a qualified service
		technician.
Air conditioner does not	Airflow is restricted.	• Make sure there are no curtains, blinds or furniture
cool as it should		blocking the front of the air conditioner.
	The temperature control may	• In COOL mode, press the Decrease ▼ pad.
	not be set correctly.
	The air filter is dirty.	• Clean the filter at least every 30 days.
		See the Operating Instructions section.
	The room may have been hot.	• When the air conditioner is first turned on, you need to
		allow time for the room to cool down.
	Cold air is escaping.	• Check for open furnace floor registers and cold air
		returns.
		• Set the air conditioner’s vent to the closed position.
	Cooling coils have iced up.	• See “Air conditioner freezing up” below.
Air conditioner	Ice blocks the air flow and	• Set the controls at HIGH (F3) FAN or HIGH (F3) COOL and
freezing up	stops the air conditioner	set the thermostat to a higher temperature.
	from cooling the room.
The remote control	The batteries are inserted	• Check the position of the batteries. They should be
is not working	incorrectly.	inserted in the opposite (+) and (–) direction.
	The batteries may be dead.	• Replace the batteries.
Water drips outside	Excessively hot and	• This is normal.
	humid weather.
Water drips indoors	The air conditioner is not	• For proper water disposal, make sure the air conditioner
	tilted to the outside.	slants slightly from the case front to the rear.
Water collects in	Moisture is removed from	• This is normal for a short period in areas with little
base pan	indoor air and drains into	humidity; normal for a longer period in very humid areas.
	rear of a cabinet where a fan
	blows it against the outdoor
	condenser coil.
TIMER feature not	A power outage or interruption	• In the case of a power outage or interruption, the unit
working properly	occurred.	TIMER feature will reset to the original setting. You may
		need to set a new time if desired.
		13

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support