Heath Zenith manual Operation, Model SL-9525, Features, Requirements, Mode Switching Summary

Motion Sensor Light Control

As an ENERGY STAR® Partner, Heath®/Ze- nith has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. This product is ENERGY STAR® compliant when used with 120 Watt bulbs.

Model SL-9525

Features

•Turns on lighting when motion is detected.

•Automatically turns lighting off.

•Photocell keeps the lighting off during daylight hours.

•LED indicates motion was sensed (day or night).

This package includes:

OPERATION

Mode:	On-Time:	Works: Day	Night
Test	5 Sec	x	x
Auto	1, 5, 10 min.		x
Manual	Until Dawn*		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate.

TEST

Put the ON-TIME switch on the	ON-TIME
bottom of the sensor in the TEST
position.
	10 5 1 TEST
AUTO
Put the ON-TIME switch in the 1, 5,	ON-TIME
or 10 minute position.
		10 5 1 TEST
MANUAL MODE

Lamp Holders	Cover
	Plate

2 Shells

Sensor

Light Control

	Light Shield	2 Wire
4 Screws		Connectors

Manual mode only works at night because daylight returns the sen- sor to AUTO.

Flip the light switch off for one sec- ond then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1 Second OFF

then...

(2 sizes included)

Gasket

2 Flood Lamps

Requirements

•The Light Control requires 120-volts AC.

•If you want to use Manual Mode, the control must be wired through a switch.

•Some codes require installation by a qualified electrician.

•This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.

© 2003 DESA Specialty Products™

... back on.

Mode Switching Summary

	TEST	Move ON-TIME Switch to
			1, 5, or 10 minutes
	AUTO		Flip light switch off
			for one second then
			back on*
MANUAL MODE

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.

595-5612-08