Installation Guide
WARNING
This installation information is designed for experienced installers and is not intended for
Any attempt to install this product in a motor vehicle by anyone other than qualified installer could cause damage to the electrical system and could result in serious personal injury or death.
❏Overview
This equipment should be installed by a professional. However, if you plan to install this unit yourself, your first step is to decide where to install it. The instructions in these pages will guide you through the remaining steps: (Please
refer to "WARNING" statement above).
Identify and label the vehicle wires.
Connect the vehicle wires to the wires of the power connector.
Install the unit in the dash. 
Check the operation of the unit.
If you do encounter problems, please consult your nearest authorized dealer.
Caution: This unit will operate with a 12 volt DC negative ground auto battery system only. Do not attempt to use it in any other system. Doing so could cause serious damage.
Before you begin installation, look for the following items included in the packing with your unit.
Warranty Card ...... Fill this out promptly
Panasonic Servicenter for Service Directory
...... Keep for future reference in case the unit
needs servicing |
|
Installation Hardware | Needed for |
installation |
|
❏Installation Hardware
No. | Item | Diagram Qty | |
Mounting Collar | 1 | ||
Plain Washer (5 mmφ ) | 2 | ||
Spring Washer (5 mmφ ) | 2 | ||
Hex. Nut (5 mmφ ) | 2 | ||
Rear Support Strap | 1 | ||
Hex. Bolt |
| 1 | |
(5 mmφ ⋅ | 25 mm) | ||
| |||
Toothed Lock Washer | 1 | ||
(5 mmφ ) |
| ||
|
| ||
Power Connector | 1 | ||
Removal Tool | 2 | ||
| |||
Antenna Connector | 1 | ||
18