American Standard SERIES 7193 Apply a bead of sealant to, Edge of the sink. Hold, Sink against

INSTRUCTIONS FOR UNDERCOUNTER MOUNTED SINK

WITH COUNTERTOP MOUNTED FAUCET.

1	Countertop	5	Apply a bead of sealant to		Countertop
							Cutout
	Perimeter		the edge of the sink. Hold
							Edge
			the sink against the
	of sink						Sealant
			under-side of the
			countertop and rotate the
	Cutout		clips to hold the sink in
			place. Snug the screws to
			hold the sink. Attach all the			12mm
	Drill a clearance hole inside the cutout line		additional clips.			(1/2")
					Support Clip
	as marked on the countertop.
2	Countertop	6
				Countertop
	Perimeter				Sink
	of sink				Surface
	Cutout
Cut opening on cut line inside the perimeter of sink.
			Mount the faucet and drain assembly
Note - Formica countertop installation only is illustrated.
			on the sink or countertop following
Contact your countertop distributor for the best method of			the manufacturer's instructions.
cutting other materials such as marble, hard synthetics, etc.
3	Countertop	7
	Template			Countertop
					Sink
	Cutout				Surface

Cut faucet holes in the countertop and remove the template.

	CAUTION	PROPER FIT
Prior to beveling the					Connect supply lines to faucet finger tight, and
			Faucet
countertop edge, be sure that			Escutcheon		carefully bend to engage with the supply stops.Tighten
the faucet escutcheon does			Countertop		connections to faucet for secure seal.
not extend onto the curved
portion of the countertop.
4			CUTOUT	8		A	B	Trap
			SUPPORT
			CLIPS					Single Bowl

Attach at least eight of the support clips to the underside
of the countertop as shown below. The location of the	Connect drain assembly hand tight to check alignment. It
clips should be as shown in the sink diagram. The wood
	may be necessary to cut off part of the tailpiece (area "A")
screws are for use in wood, plywood, or particle board
	or part of the horizontal leg of the trap (area "B").
(drill appropriate pilot hole). The inserts supplied are for
use in marble or hard synthetic material.	Secure joint for watertight assembly.

791393 - 100 Rev . A 3