Simple Setup
remote control
step3 AC cord connection
To household AC outlet (AC 120 V, 60 Hz)
AC IN | Main unit |
| |
AC power supply cord (included) |
|
|
|
Conserving power | [Note] |
The main unit consumes a small amount of power, even when it is in | The included AC power supply cord is for use with the main unit only. Do |
standby mode (approx. 0.3 W). To save power when the unit is not to be | not use it with other equipment. Also, do not use cords for other |
used for a long time, unplug it from the household AC outlet. You will | equipment with the main unit. |
need to reset some memory items after plugging in the main unit. |
|
step4 Preparing the remote control
connection/Preparing the
∫Batteries
Insert so the poles (i and j) match those in the remote control.
Press in and lift up.
R6/LR6, AA
≥mix old and new batteries.
≥use different types at the same time.
≥heat or expose to flame.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a long period of time. Store in a cool, dark place.
AC cord
RQTX0014
∫ Use
Replace the cover. | Aim at the remote control signal sensor (➜ page 11), avoiding | |
| ||
≥Do not use rechargeable type batteries. | obstacles, at a maximum range of 7 m (23 feet) directly in front of | |
the unit. | ||
|
8