ASSIGN ZONES AND LIGHTS PROGRAMMING THE INTERNET HUB
7.After you have assigned a name for each light or device, you may now learn the light to the Wireless Module. Refer to the User’s Instructions of that specific receiver to put the unit into ‘Learning’ mode, then press the [Learn] button on the Internet Hub interface. The Signal LED will flash, then
turn off on the Internet Hub indicating the ‘Learn’ code has been sent.
8.This light is now programmed to the Wireless Module. Repeat the same instructions to program the rest of the lights.
9.To operate the lights, go to the ‘Zone Control Page’.
For example, select [Kitchen] and choose the light you want to control.
ASSIGN ZONES AND LIGHTS PROGRAMMING THE INTERNET HUB | 9 |
|
|
|
|