Panasonic SC-HTB10 Remote control code, Changing this unit’s settings, Operating Instructions

If this unit is connected to a non-Panasonic ARC compatible TV, connect using an optical digital audio cable. (> 10)

≥After connecting the optical digital audio cable, the setting of this unit must be changed to specify the audio input terminal. (> right, “TV Audio”)

Audio is output from the TV speakers and not this unit’s.

≥When connected to a VIERA Link (HDAVI Control) compatible TV, change the audio output settings to this unit. (> 14)

Both main and secondary audio are output simultaneously.

≥Change the digital audio output setting on the TV or connected device and then select the desired audio channel. (For details, refer to the operating instructions for the TV or connected device.)

Changing this unit’s settings

Refer to “Troubleshooting” (> 16) before changing any of the following settings.

The settings remain intact even if you switch the unit to standby mode.

Awill blink green once when the setting is changed.

A

∫VIERA Link

Changes to this setting become effective after turning off and on all the connected devices.

Set “VIERA Link” to “Off”.

Set “VIERA Link” to “Off” when you do not want to use “HDAVI Control”. (> 16, “General operation”)

Press and hold [INPUT SELECTOR] on this unit and [BD/DVD] on the remote control for more than 2 sec.

≥When set to “Off”, the ARC function is not available. Be sure to connect using the optical digital audio cable. (> 10)

Set “VIERA Link” to “On”.

Press and hold [INPUT SELECTOR] on this unit and [SOUND EFFECT] on the remote control for more than 2 sec.

∫TV Audio

Set “TV Audio” to “ARC Off”.

Set “TV Audio” to “ARC Off” only when using an optical digital audio cable with an ARC compatible TV. (> 16, “Sound”)

Press and hold [INPUT SELECTOR] on this unit and [TV] on the remote control for more than 2 sec.

Set “TV Audio” to “Auto”.

Press and hold [INPUT SELECTOR] on this unit and [CLEAR-MODE DIALOG] on the remote control for more than 2 sec.

Remote control code

When other Panasonic products respond to this unit’s remote control, change the remote control code on this unit and the remote control.

Preparation

≥Turn off all other Panasonic products.

≥Turn on this unit.

Change the remote control to code 2:

1Aim the remote control at this unit’s remote

control sensor.

2Press and hold [CLEAR-MODE DIALOG] and [BD/DVD] on the remote control for more than 4 sec.

A

Awill blink green once when the code of this unit is changed.

≥If the unit does not operate after changing the code, repeat steps 1 and 2.

≥To change the remote control to code 1, repeat the steps above, but replace [BD/DVD] with [TV].

Operating Instructions

17