Components
The images shown in this installation instructions are for illustrative purpose only. Check the supplied components before starting.
∏ 2 Wall mount brackets
∏2 Screws
∏ 2 Lock pins
∏ | AC mains lead | (Saudi Arabia and Kuwait) | (Others) |
| (Australia and New Zealand) |
Commercially available components (not supplied) |
|
≥ Screws for wall mounting | ≥ Screws to attach fall prevention cord to wall |
≥Fall prevention cord
≥Use commercially available screws with a nominal diameter of ‰4.0 mm that are suited to the wall material (wood, steel frame,
concrete etc.) you are attaching the wall mount brackets to.
≥Product numbers correct as of April 2010. These may be subject to change.
Installation procedure
Never use any other method than specified to install
Attaching the wall mount brackets
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
≥Keep the screws out of reach of children to prevent swallowing.
≥Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1 On the rear of the unit:
Place the wall mount bracket by aligning the holes in the wall mount bracket with the projecting parts A.
2 Screw the wall mount bracket firmly into place.
|
≥Screw tightening torque: 80 N0cm to 120 N0cm.
≥Repeat the steps above when installing the second wall mount bracket.
22