9 | INSTALL HANDLES | 6 |
| Push ADAPTER (1) on VALVE | |
| STEM (2), so that the hole of the | 5 |
| ADAPTER (1) without spline is |
facing up.
6 | INSTALLATION OF OPTIONAL METAL LEVER |
HANDLES (Supplied with Faucet) |
Thread PORCELIAN LEVER HANDLE (2)
and remove INDEX BUTTON with MOUNTING ROD ASSEMBLY (1).
Insert MOUNTING ROD ASSEMBLY (1) into METAL HANDLE (3)
Thread HANDLE BASE (3) onto
VALVE ESCUTCHEON (7)
Push LEVER BALL (4) onto |
4
and HANDLE COLLAR (4).
Thread HANDLE ASSEMBLY (6) into ball of HANDLE BASE (5) and tighten.
ADAPTER (1). | TOP |
Find correct position of HANDLE (4) by adjusting male teeth on ADAPTER (1) to female teeth in
LEVER BALL (4).
Secure LEVER BALL (4) with HANDLE SCREW (5).
SPLINE END
Push INDEX CAP (6) DOWN in hole of LEVER BALL (4).
3
1
2
7
24
3
1
6
5
10 TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks. 
Remove AERATOR (3).
1
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3).
11 CHECK DRAIN CONNECTIONS
Operate
Release
5
1
3
4
WASTE
OUTLET
2
COLD
“P” TRAP
2
HOT
12 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
13 SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position. |
|
|
Remove INSERT and HANDLE SCREW. | 2 | 90 |
Slip HANDLE with ADAPTER off. |
| |
Remove SPRING CLIP (1). |
| 1 |
Lift STOP WASHER (2), turn 90 and replace. |
| |
Replace SPRING CLIP (1). |
|
|
Replace ADAPTER, HANDLE, SCREW, and INSERT. |
|
|
Spray may accumulate dirt causing distorted and reduced water flow. Remove spray and rinse clean.
Replace Spray and operate handles several times from OFF to ON position. Do not force, handles turn only 90˚.
US60385 Rev. 1 . 2
4