American Standard 6065.162 Flush OUT Supply Lines Fig, Left or Right Hand Installation Fig

4FLUSH OUT SUPPLY LINES; Fig. 6

1.Remove COVER (1) from SUPPLY STOP (2).

2.With a flat blade screwdriver open SUPPLY STOP (2).

3.Turn on water supply to flush line of any debris or sediment.

4.Close SUPPLY STOP (2) and replace COVER (1).

Fig. 6

2

REMOVE COVER

1

2

COUNTER-CLOCKWISE

OPENS CONTROL STOP

CLOCKWISE CLOSES

CONTROL STOP

45 LEFT OR RIGHT HAND INSTALLATION; Fig. 7

The UNIT is shipped with the inlet flange on the right side. If needed, the orientation can be reversed by following the steps below.

1.Loosen SET SCREW (1) with 2.5mm Hex Wrench (4) in back of top half of FLUSH VALVE (2). Fig. 7a.

2.Rotate TOP (2) to the right and pull off. Fig. 7b.

3.Rotate bottom half of FLUSH VALVE (3) 180˚. Fig. 7b.

4.Replace TOP (2) and rotate until key engages than tighten SET SCREW (1). Fig. 7c, 7d.

Fig. 7
		2
2	1	RED+
	BLACK-
4		3
Fig. 7a		Fig. 7b
		180˚
	2
	Fig. 7c	KEY
	4	1
	Fig. 7d
4		M968699 Rev. 1.3