American Standard 6065.122 Install the Sweat Solder Adapter Fig, Escutcheon and Supply Stop Fig

1INSTALL THE SWEAT SOLDER ADAPTER; Fig. 3

CAUTION	Turn water supplies off
	before beginning

Note: Install Optional Sweat Solder Adapter (Supplied) for copper pipe supply line. Fig. 3.

1.Measure the distance (A) from the finished wall to the center of the inlet spud on the fixture.

2.Cut the supply pipe 1-1/4" (A-B=C) shorter then the measurement taken in Step 1. File any rough edges off the end of the supply pipe.

3.Clean the end of the supply pipe. Push the threaded Adapter on until it is seated against the internal stop. Sweat the Adapter to the pipe.

2INSTALL COVER TUBE, WALL

ESCUTCHEON and SUPPLY STOP; Fig. 4

1.Measure from finished wall to first thread of Adapter or threaded supply pipe (dimension “X”). Cut COVER TUBE (1) to length (X). Apply Teflon Tape to the threaded end of the Adapter or supply pipe. Fig. 4a.

2.Push the COVER TUBE (1) into the WALL ESCUTCHEON (2). Slide both onto the SUPPLY PIPE

(3). Fig. 4b.

3.Push the COVER TUBE (1) in to expose the threads of the supply pipe. Fig. 4c. With a wrench thread the SUPPLY STOP (4) onto the SUPPLY PIPE (3). Align and tighten. Fig. 4c.

4.Pull COVER TUBE (1) against SUPPLY STOP (4) and push WALL ESCUTCHEON (2) against finished wall.

3INSTALL DOWN TUBE AND VACUUM BREAKER; Fig. 5

1.Place the SPUD FLANGE (1) over the spud on the Fixture.

2.Thread SPUD COUPLING NUT (2) onto Spud. Make sure SEAL WASHER (3) and FRICTION WASHER (4) are installed. Do not tighten fully.

3.Insert the DOWN TUBE (5) into the SPUD COUPLING NUT (2) and push it down.

Note: If cutting Down Tube (5) to size, note that Critical Line (C/L) on Vacuum Breaker must typically be 6" (152mm) above fixture. Consult

Code for details.

Fig.3

FINISHED WALL

CENTER LINE OF

FIXTURE SPUD

			A
	(A-B)=			B
		C				32mm
FILE EDGES					(1-1/4)

CLEAN

ADAPTER

	SOLDER
	ADAPTER
Fig. 4	FINISHED WALL
Fig. 4a	X
		TEFLON TAPE
Fig. 4b		2
		1
	3
	2	X
Fig. 4c		4

1

Fig. 5

5

2 3

4

1 1-1/2" TOP SPUD

3 M968699 Rev. 1.3