INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the ADAPTER (1) without a spline is facing up. See figure "A". Tighten STEM SCREW (3) to secure ADAPTER (1).
Find correct position of LEVER HANDLE ASSEMBLY (4) or CROSS HANDE ASSEMBLY (5) by adjusting male teeth on ADAPTER (1) to female teeth in HANDLE (4, 5).
Thread LEVER HANDLE ASSEMBLY (4) or CROSS HANDE ASSEMBLY
(5)onto DECK ADAPTER (6) until snug against mounting surface.
DIVERTER KNOB:
Install HANDLE ADAPTER (8) onto valve stem.
Push DIVERTER KNOB (7) onto HANDLE ADAPTER (8).
Install RING (9) onto DIVERTER KNOB (7) and tighten with HANDLE SCREW (10).
Press on KNOB CAP (11).
11
10
45
TOP
Figure "A"
SPLINE END DOWN
THREAD ON
TO DECK
ADAPTER
1
3
2
6
9
7
8
VALVE STEM 
WATER SUPPLY CONNECTIONS
NOTE: FLEXIBLE SUPPLIES ARE NOT INCLUDED AND HAVE TO BE PURCHASED SEPARATELY.
Connect water supplies to FAUCET (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D.
Do not over tighten. Be careful not to kink copper supply when bending. Use tubing cutter to cut to proper length.
1
2 | COUPLING NUT |
3
HotCold
FERRULE
FINISH DRAIN INSTALLATION
Position BIDET fixture and secure to floor.
Insert lift rod into lift rod guide.
Position EXTENSION ROD (1) onto
Remove one end of CLIP (4) from PIVOT ROD (7) by squeezing ends together while sliding.
Insert PIVOT ROD (7) into second or third hole in EXTENSION ROD (1) and reassemble CLIP (4). (EXTENSION ROD (1) may need to be bent.)
Adjust STOPPER height by repositioning EXTENSION ROD (1) and tightening THUMBSCREW (3).
Using metal TAILPIECE (5), make connection to the TRAP (6).
2
1
3
7
1
5 
4
6
. 3 & 7