INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Tropic Cadet®3
Elongated, Right Height™ Toilets
Models 2455 / 2457 / 2459
Triumph Cadet®3
Elongated, Right Height™ Toilets
Models 2490 / 2491 / 2492
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife | Regular Screwdriver | Adjustable Wrench | Sealant | Tape Measure |
Hacksaw | Wax Ring/Gasket | Flexible Supply Tube | Closet Bolts | Carpenters Level |
1REMOVE OLD TOILET
a.Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b.Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c.Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d.Remove closet bolts from flange and clean away old wax, putty, etc. from base area. NOTE: Mounting surface must be clean and level before new toilet is installed!
U R E U S E
2 ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed below:
For 4007 Tanks: 12" (305mm)
FINISHED WALL |
| |
| SUPPLY | |
| AS | |
| REQ'D. | |
12" | FINISHED | |
FLOOR | ||
(305mm) | ||
|
3
CLOSET FLANGE
A
CLOSET BOLTS
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90°, and slide into place 6" (152 mm) apart and parallel to wall.
S A V E F O R F U T
4 |
|
SEALANT | WAX RING |
|
5
FLANGE
NUT
TAPERED
WASHER
CLOSET
BOLT
INSTALL WAX SEAL
Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealant around toilet base.
POSITION TOILET ON FLANGE
a.Unplug floor waste opening and install toilet on closet flange so bolts project through mounting holes.
b.Loosely install retainer washers and nuts. Side of washers marked "THIS SIDE UP" must face up!
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A S A m e r i c a , I n c . | |
© A S A m e r i c a , I n c . 2 0 0 8 |
|