Rinnai EX22C (RHFE-559FTA), EX17C (RHFE-434FTA) Set back, Humidifier and Air Flow Direction

Page 10

Set back

This function allows a minimum room temperature to be pre-set, between 38ºF and 78ºF (in 2ºF increments). This temperature should be set below the room temperature setting. The default setting is 60ºF. Once the Set back function is selected the appliance will start heating whenever the room temperature falls below the selected temperature, regardless of timer or manual settings.

Follow these steps to set and operate the Set back feature:

1.Make sure the heater is turned OFF.

2.Press the “Set back” button. The light above the button will come on.

3.Press the up and down buttons to set the minimum temperature.

When the “Set back” indicator is on, frost protection is operating, and will always prevent the room temperature from falling below the pre-set minimum temperature (as long as electric power and gas is supplied).

To turn this feature off, press the “Set back” button.

The unit will retain its ON or OFF setting after a power failure. (Default setting at the factory is on.)

Humidifier and Air Flow Direction

Adding Water to the Humidifier

Do not remove the bottom trim panel or the humidifier tray while warm air is flowing. Wait 5 minutes after turning the unit off.

Warm air is humidified when it passes over the water in the tray.

To fill the tray, remove the bottom panel by pushing on both sides and pulling it toward you. Pull the tray out and fill with water. Do not exceed the fill line. Push the tray back in and attach the bottom panel. Do not operate the appliance unless the humidifier tray is installed.

During operation a small amount of condensation is produced in the flue system and drains into the humidifier tray.

Adjusting Air Flow Direction

Do not adjust the air flow louvers while warm air is flowing.

The vertical louvers may be adjusted to move the air flow more to the right or to the left.

Use a screw driver or similar object to bend each louver to the desired position.

Do not bend repeatedly (no more than 5 times) or else the louver will break.

The horizontal louvers (which determines the vertical air flow direction) are fixed and cannot be adjusted.

10

Rinnai Corporation EX17C / EX22C Manual

Image 10
Contents EX17C RHFE-434FTA EX22C RHFE-559FTA Table of Contents Safety Definitions Consumer Safety InformationSafety Behaviors and Practices Safety Features SpecificationsAppliance Specifications Natural Gas Propane Gas FeaturesFlue Manifolds Name Kit No Fits wallsOperating Instructions Getting to Know your New Heating ApplianceChild Lock Sensible Temperature ControlControl Panel DisplaySetting the timers Setting the ClockSetting and Operating the Timers Operating the timersEconomy Mode Information Economy Energy Saving ModeOverride Function Humidifier and Air Flow Direction Adjusting Air Flow DirectionSet back Adding Water to the HumidifierCare and Maintenance Before Making a Service Call At IgnitionFault Codes Code Displayed Fault RemedyTroubleshooting Restart FunctionInstallation Instructions General InstructionsClearances to Combustibles Gas ConnectionAttach Back Covers Sides Only Dimensions 22.9 582 mm 29.9 760 mm 10.1 in 257 mm 172 mm 85 mmFlue Terminal ClearancesDescription Canadian Installations US Installations Flue Terminal ClearancesInstallation Parts ‘A’ Flue units only For weatherboard installationsConfiguration viewed from behind the appliance Drilling Flue HoleFlue Manifold Installation Flue Manifold Installation Extension Kit Installation IncorrectClearances Installing the Exhaust LineConnecting the Air Intake Hose ClampsExtension Kits and Parts Description FOT-201 FOT-219 FOT-220 FOT-221 FOT-158 FOT-190Connecting the Appliance Slip the securing clip over the sleeve as ShownAdjust Gas Pressure Settings AltitudeFinal Assembly Normal Operating SequenceOperating Instructions Turn the manual valve clockwise To the full OFF positionCut-Away Diagram Wiring Diagram Type 18 AWG wire or its equivalentLadder Diagram EX22CParts List Parts List Parts List Parts List Parts List Parts List Parts List Liste de pieces EX17CSpacer Bracket Support espaceur Combustion Fan Casing Ensemble de carter de ventilateur Conversion Kits Optional / Kits de conversion facultatifs ModèleConsumer Support Warranty InformationLimited Warranty Gas Direct Vent Wall FurnaceHow do I get service? What is not covered? State Regulations Important In the State of Massachusetts 248 CMR 4.00EX17C RHFE-434FTA EX22C RHFE-559FTA Table des matières Sécurité du consommateur Définitions de sécuritéSpécifications de l’appareil SpécificationsDispositifs de sécurité Protection de surintensité Un fusible en verre sur leGaz naturel Gaz propane CaractéristiquesCollecteur de fumée Name Kit No Murs d’ajustementsInstructions d’utilisation Connaissance du nouveau chauffageMarche / Arrêt Panneau de commandesVerrouillage pour les enfants Réglage et utilisation des minuteries Mise à l’heureUtilisation manuelle du chauffage Paramétrage des minuteriesÉconomie Mode de conservation d’énergie Fonction de surpassementAjout deau dans lhumidificateur Programmation de température minimaleHumidificateur et direction du flux d’air Réglage de la direction du flux dairSoins et entretien AtÀ l’allumageIgnition Avant d’appeler pour de l’aideAutresOther pointsPoints Codes de défauts Code Affiché Défaut RemèdeFonction de redémarrage DépannageInstructions d’installation Instructions généralesDégagement par rapport aux combustibles Connexion de gazFixation des couvercles arrière Côtés seulement Installation Standard DE Tubulure DE Conduite DE Cheminée Dégagements en sortie de cheminéeRéf Description Installations Canada Installations USA Dégagements en sortie de cheminée SuiteDimensions Pièces d’installation ‘A’ Flue units onlyPerçage du trou de cheminée Installation du collecteur de fumée Installation du collecteur de fumée Suite Installation du kit d’extension Dégagements Attaches Installation du kit d’extension SuiteInstallation de la conduite d’évacuation Connexion de la conduite d’évacuationInstallation de kit d’extension Kits et pièces d’extensionBranchement de l’appareil Ajustage et Reglage de la Presion de Gas LInspection visuelle de Flamme La Séquence normale dOpérationAssemblée finale Instructions de mise en œuvre Lire Avant DE Mettre EN MARCHE, Pour Votre SécuritéSchéma en coupe RinnaiSchéma de câblage Calibre 18 AWG ou équivalentDiagramme logique Garantie limitée Service à la clientèleInformations de garantie Appareil de chauffage mural au gaz à ventilation directeGarantie limitée Suite Limitation des garantiesRinnai Corporation EX17C / EX22C Manual Rinnai Corporation EX17C / EX22C Manual Rinnai’s other fine products

EX17C (RHFE-434FTA), EX22C (RHFE-559FTA) specifications

The Rinnai EX17C (RHFE-434FTA) and EX22C (RHFE-559FTA) are innovative wall-mounted gas heaters that provide efficient and cozy heating solutions for indoor spaces. Manufactured with advanced technology, these models are designed to meet diverse heating needs while ensuring user comfort and safety.

One of the standout features of both the EX17C and EX22C is their energy efficiency. With a high energy star rating, these heaters minimize energy consumption, making them ideal for environmentally conscious consumers. The EX17C can deliver an impressive 17 kW of heating power, while the EX22C offers up to 22 kW, accommodating various room sizes and layouts effectively.

Both models utilize Rinnai’s advanced direct vent technology. This system allows fresh air from outside to be used for combustion, ensuring optimal heating performance without depleting indoor oxygen levels. This feature not only enhances comfort but also contributes to improved indoor air quality. Additionally, the closed combustion system ensures that exhaust gases are safely vented outside, providing a safer environment for occupants.

In terms of design, the EX17C and EX22C are sleek and modern, fitting seamlessly into various interior styles. Their wall-mounted configuration saves floor space, making them suitable for smaller rooms or homes where space optimization is a priority. The adjustable heat settings enable users to customize their heating preferences according to the season or personal comfort levels.

User convenience is a core aspect of both models, which come equipped with an intuitive electronic control panel. This feature allows for easy temperature adjustments and scheduling, ensuring that optimal heat levels can be maintained without constant manual intervention. Some models also offer remote control capabilities, enhancing usability for consumers.

Safety is paramount in Rinnai's design philosophy, and the EX17C and EX22C include multiple safety features such as flame failure detection and automatic shut-off. These mechanisms ensure that any irregularities in operation are promptly addressed, providing peace of mind for homeowners.

In conclusion, the Rinnai EX17C and EX22C offer modern, energy-efficient heating solutions with advanced technology, user-friendly features, and a focus on safety. These models are ideal choices for anyone looking to enhance their indoor heating experience while maintaining energy efficiency and comfort.