Rinnai REU - 16 FUA - E With temperature controller fitted, Without temperature controller fitted

Page 17

ERROR MESSAGES

Troubleshooting without controllers

If you have not installed temperature controllers and experience the following symptoms, please carry out the suggestions below. If symptoms continue, please contact Rinnai for advice.

Fault

Remedy

 

 

Heater does not attempt

Check the power is on at the heater.

to start at all.

Check the cold water valve supplying the heater is open.

Heater starts then shuts

Check the power is on.

down immediately.

Check the gas valve at the heater and at the gas meter is fully open.

 

Open the hot water tap fully.

Heater starts then the

Check the power is on.

water goes cold.

Open your hot water tap further or try another hot outlet.

NOTE: Faults caused by insufficient gas/water supply or gas/water quality and installation errors are not covered by the manufacturer’s warranty.

Installations with circulation pumps

With temperature controller fitted.

If you have an installation using a secondary circulation pump this must be switched off so that there is no flow through the heater when starting or after a power failure. If the pump is running the unit will not operate (no display on the controller). Isolate pump then start heater before restarting pump. This is a safety feature.

The pump should also be fitted with a thermostat to prevent the return temperature reaching the heater set point temperature.

Without temperature controller fitted.

The heater should automatically reset and provide water at the temperature set by the internal limit switches.

17

Image 17
Contents Infinity 16 Page Contents Responsibilities of the User Users Instructions Operating Noise Level is Very LOW Features and BenefitsImportant Information OFF Page Suggested temperatures are Temperature ControlsButtons Temperature Controls OperatingAdjusting Temperature Using the Temperature ControllersBathroom temperatures should be no more than 500C Switching the system onUsing hot water Page Temperature Controls Information Caring for the Infinity Code Fault Remedy Displayed Error MessagesWithout temperature controller fitted With temperature controller fittedStandard system Restarting the Rinnai Water HeaterStop Installation InstructionsImportant Information UK Installation InstructionsPage HOT Water Supply Operation Operation PrincipleMain Components Main Components Appliance Location Installation Instructions PositioningWater Supply Installation Instructions ConnectionsWater Connection Gas ConnectionMains UK INST. Instructions ConnectionsSingle Infinity Direct Flow Installation Instructions SchematicsGeneral Information UK INST. Instructions VentilationFlue Length Flue Requirements InstallingGroppalli Muelink & GrolUK Flue Requirements Installing UK Flue Requirements Positioning Temperature Controls Installation Page Page Page GAS Pressure Setting Page Computer Programming DIP Switch SettingDimensions Infinity Technical DetailsFlow Chart Wiring Diagram Mortor Diagnostic PointsLetter of Compliance CE Certificate Commissioning Check List Standard Use UK WarrantyElectrical Supply…………………………….…………..…………….….230V AC 50Hz 1ph SpecificationContact

REU - 16 FUA - E specifications

The Rinnai REU-16 FUA-E is a cutting-edge tankless water heater designed for efficiency and convenience. This model is part of Rinnai's renowned line of high-performance appliances, catering to both residential and commercial applications. It boasts a sleek design coupled with advanced technology that sets it apart in the crowded water heating market.

One of the most notable features of the REU-16 FUA-E is its impressive heating capacity. It is capable of delivering hot water on demand, with a maximum output of 16 liters per minute. This means you can comfortably run multiple hot water fixtures simultaneously without experiencing a drop in temperature or flow rate. Whether you’re taking a shower, running the dishwasher, or washing clothes, this unit meets the demand with ease.

The REU-16 FUA-E employs a state-of-the-art condensing technology, which enhances its efficiency by capturing and reusing some of the heat that would otherwise escape through the flue. This allows for an energy efficiency rating of up to 95%, significantly reducing energy bills and environmental impact compared to traditional storage water heaters.

Another key characteristic of this unit is its compact size. The Rinnai REU-16 FUA-E can be installed in smaller spaces, making it an ideal option for apartments, houses, or commercial properties with limited room for bulky tank units. Its flexibility in installation positions—whether indoors or outdoors—provides additional versatility to users.

Safety is also a primary concern with the REU-16 FUA-E. It comes equipped with numerous safety features, including an anti-freezing function, overheat protection, and venting safety controls. These safeguards ensure safe operation for you and your family, providing peace of mind whether it’s running constantly or in standby mode.

In terms of controls, the Rinnai REU-16 FUA-E offers modern digital displays that provide real-time monitoring of water temperature and status. This user-friendly interface makes it easier for homeowners or users to adjust settings according to their preferences.

Overall, the Rinnai REU-16 FUA-E encapsulates innovation and efficiency in water heating. Its combination of advanced technology, high performance, compact design, and safety features makes it a reliable choice for those seeking a consistent supply of hot water without the limitations of traditional systems. Whether for residential use or commercial applications, the REU-16 FUA-E is engineered to provide lasting performance and convenience.