Securing the Lower Wall Plate
Level
Wall
Plate
Figure 11
1.Level and secure the plate to the wall with the reference arrow facing up to the ceiling (Figure 11).
2.Secure the plate using the provided lag bolts and washers.
Securing the Upper Wall Plate
Wall
Marks
Wall
Plates
Figure 13
1.Drill four (4) ¼" pilot holes in the marked wall (Figure 13). These pilot holes will be for the upper mounting bracket.
Marked Wall
Wall Plate
Template
Figure 12
3.When the bottom wall plate is properly installed to the wall.
4.Lay the carton template on top of the wall plate.
5.Lay the top wall plate on top of the cardboard template and mark the four (4) mounting points (Figure 12).
Power Source
Area
Wall Plates
Figure 14
2.Level and secure the plate to the wall with the reference arrow facing up to the ceiling.
3.Secure the plate using the provided lag bolts (Figure 14).
CAUTION: Do not over tighten the mounting hardware.
NOTE: CHECK THE MOUNT FOR PROPER
TIGHTNESS AND SECURITY.
Page 8 | Installation Instructions |