Mounting the Display
WARNING: AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
Top
Bottom
Figure 15
1.Raise the flat panel with the mounting brackets secured to the flat panel and insert the top and bottom hooks from each bracket to the rods from the wall plates (Figure 15).
Lateral Shift
M6 x 30 Lateral
Shift Screw
M6 x 30 Lateral
Shift Screw
Figure 16
2. Make any lateral shift adjustments and lock the display in place by tightening the two (2) M6 x 30 (mm) Phillips screws found on the bottom of the mounting brackets (Figure 16).
CAUTION: Do not over tighten the M6 screws to the rods.
Installation Instructions | Page 9 |