Installation Instructions

SCM-103

THE SCM-103 IS HEAVY. IT IS STRONGLY RECOMMENDED THAT THREE PEOPLE PERFORM ALL INSTALLATION STEPS.

Step 6. Locate the ½”-20 Nuts & ½” flat washer.

Step 7. Measure 1 ¾” inches up the threaded stud attached to the cable and thread one ½-20 nut into position.

Leveling adjustment can be made at this stage by setting the nut position at different heights on the threaded post attached to the cable.

Step 8. Slide one ½” flat washer up to the nut and insert the end of the stud into the bottom hole of the mounting bracket. Step 9. Locate two ½”-20 nuts & one ½” flat washer.

Step 10. Tighten the two nuts until cable is locked tight into position.

Page 11