Stovax PR0731 manual Lighting the Linea, Have YOU Purged the GAS SUPPLY?

INSTALLATION INSTRUCTIONS

INSTALLATION

2.15Replace the glass frame; ensure the top of the frame is hooked on the tabs at the top of the appliance and replace the nine screws with the three longest screws used in the bottom fixing holes. Tighten from the top down.

HAVE YOU PURGED THE GAS SUPPLY?

2.16Connect the gas supply to the isolation device using 8mm pipe. Connect a suitable pressure gauge to the test point and turn on the gas supply and check for leaks.

2.17Light the appliance and set it to maximum. Check the pressure corresponds to the data badge. Turn the gas off and replace the test point screw. Turn the gas on and check the screw for leaks.

THE YELLOW FLAMES WILL APPEAR WHEN THE FIRE HAS GAINED SUFFICIENT HEAT - TYPICALLY 20 MINUTES.

3.LIGHTING THE LINEA

Note: The Emergency Shut Off switch must be in the ON

position, refer to Section 2, User Instructions. There are two ways of lighting the Linea:

•by thermostatic remote control

•using the fire’s touchpad

THERMOSTATIC REMOTE CONTROL

9

AR1883

This remote controls the gas fire. In ‘MANUAL MODE’ you can:

•turn on the main burner

•regulate the flame from low to high and back

•turn off the burner

In ‘TEMP MODE’ you can:

•set the room temperature so the fire automatically maintains that temperature

In ‘TIMER MODE’ the fire:

• turns on and off according to the set time periods

•automatically regulates the room temperature during the set periods

TOUCH PAD CONTROL

10

AR1885

•Press the ON-OFF button to light the appliance, (up to

30 seconds)

•Press the UP button to increase the flame height

•Press the DOWN button to decrease the flame height. At the lowest point it goes to ‘standby mode’, (only pilot

lit)

•Press the ON-OFF button to turn the appliance off

4.REPROGRAMMING HANDSET/CONTROL BOX

•Remove the battery cover from the handset to see the four DIP switches, Diagram 11

11

AR1935

14