Stovax PR0731 manual Control box

SERVICING INSTRUCTIONS

REPLACING PARTS

12

	C					C
	C
C						C
							C
		C
				C
			C		AR1338

10.3Remove the main burner as described in section 2.

10.4Remove the locknut from the injector. See diagram 13

13

AR1345

10.5 Remove the feed pipe from the gas valve. See diagram 14.

14

AR1994

10.6 Remove the feed pipe with the injector attached from the

appliance. Note the orientation of the injector on the pipe.

10.7Reassemble in reverse order and check for gas leaks.

11.control box

11.1Remove the lower panel, Diagram 6

11.2Press on/off switch retaining clips in and pop put the switch. Turn the switch to pass it through the retaining bracket.

11.3Remove the two screws holding the control box to the bracket. Slide the control box to the right and remove from the bracket.

11.4• Remove the two thermo current cables by removing the two screws, Diagram 15

• Remove the eight loom wire from the control box,

Diagram 15

15Eight wire cable

Thermo current cables

Touchpad extension cable

Battery extension cable

AR1915

•Remove the battery extension cable, Diagram 15

•Remove the touch pad extension cable, Diagram 15

The control box can now be replaced.

11.5After replacing the control box you may need to reprogram the handset:

•Press and hold the reset button on the control box until you hear two signals. After the second longer signal:

•Release the reset button and within 20 seconds

-Press the DOWN button on the handset until you hear an additional long signal confirming the new code

•Refer to Section 4 of the Installation Instructions to set new code

21