M-Audio 66 manual Appendix B -If You Use An External Mixer

Page 46

Appendix B -If You Use An External Mixer...

Our main objective is to get the signal we want to record to the Delta 66, and to monitor the outputs from the Delta 66. The Delta 66 has a mixer contained in its PCI chip that allows you to mix hardware inputs and software outputs and send it to an analog stereo output pair and/or the S/PDIF out. The Delta 66 also allows you to record that mix into your music software as a hardware input. Still, some of you may choose to use a mixing console to achieve your multi-tracking goals.

A mixing console (sometimes referred to as mixing ‘board’ or ‘desk’) that is designed for multi-track recording has the ability to fulfill these two basic functions

getting the signal to the recording device, and receiving the outputs of that recording device for mixing or monitoring. In this sense, a recording console is two mixers in one. A mixer designed for recording will also have the ability to send to one or more mixdown decks, to monitor these mixdown decks, to control separate control room and studio listening levels, as well as other recording-specific functions.

There are two basic layouts for the recording console, “split section” and “in-line.” The split section design is arranged with a recording or ‘channel’ section (to send the signal to the recording device) side-by-side with a monitoring section (to receive the outputs of the recording device). The in-line design has the recording and monitoring sections “in line” within each channel module, so that each channel has two line inputs.

The recording section is distinguished by its bussing system, which takes the recording channel signal through a summing matrix to multiple outputs- usually in multiples of eight. It could be said that an ‘8-buss system’ is designed for 8 track recording, and a 24-buss system for 24 track recording, etc., but this is not written in stone.

What we are describing here is the extreme- a professional, costly piece of gear that has been purchased for this one specialized purpose. There are features inherent in other types of consoles, however, that will allow us to perform these two separate functions of recording and monitoring. A sound reinforcement or a broadcast console, and in some cases a recording console, might offer a bussing system in the form of “sub-mix outs.” These are usually arranged in stereo pairs with a set of level control faders for each pair. This configuration can be effectively used for recording, as long as the record channels are taken out of the stereo buss. The difference here is that there is no real distinction between the recording and monitoring sections.

45

Image 46
Contents Delta Table of Contents Delta 66 ManualWhat’s in the Box? IntroductionAbout the Delta 66 Digital Recording Interface Product Features & Specifications Minimum System RequirementsBreak-Out Box Front Panel Hardware Installation Quick Guide to Getting StartedDelta Driver & Software Installation Windows 98 InstallationWindows 95 Installation Windows NT Installation Macintosh InstallationVerifying Windows Driver Installation Delta System Overview Verifying Delta Control Panel Installation, PC & MacDelta’s Analog Input/Outputs Digital Monitor Mixer Patchbay / RouterUsing the Delta 66 with your Software Application SynchronizationPage Page Delta 66 Control Panel Software Monitor MixerPage Page Patchbay/Router Page Hardware Settings Page Page Pdif Page Save, Delete, Load Buttons H/W Installed AboutTypical Setup #1 Delta 66 Recording TutorialsPage Page Page Page Page Typical Setup #2 Page Page Page Typical Setup #3 Transferring from DAT to Delta Transferring from Delta 66 to DAT, monitoring with DAT Troubleshooting Page Page Page Page Digital Audio Appendix a Technical SpecsAnalog Audio Adapter Resource RequirementsAppendix B -If You Use An External Mixer Page Warranty Terms and Registration Warranty Terms Warranty Registration070212Delta66UGEN01