M-Audio 66 manual

1.Plug the microphones into the mic inputs 1 & 2 of the pre-amps. Plug the guitars into the high impedance inputs 3 & 4 of the pre-amps.

2.Plug the outputs of the pre-amps 1-4 into the hardware inputs 1-4 of the Delta 66. Usually pre-amp outputs are balanced, so if they are, use TRS cables and set the Delta +4/Consumer/-10 input switches to the +4dB setting in the Hardware Settings page of the Delta Control Panel.

3.Plug the hardware outputs 1-4 of the Delta 66 into your mixer’s inputs 1-4 (using 1-4 is recommended for convenience, but not necessary). Some mixers run at -10 line level, and some at +4. Many mixers may be set either way and actually have their own +4/-10 switch(es). Let’s assume that our mixer runs at +4, so set the Delta +4/Consumer/-10 output switch to +4 in the control panel. At this point we’ll assume that all mixer faders are down.

We’re now physically set up to monitor, record, and playback audio with the Delta 66 and related components. The next steps involve the settings in the Delta Control Panel. We’ll use the same settings as Typical Setup #1 for the Delta Control Panel’s ‘Hardware Settings’ page, i.e. “Internal Xtal”, “Reset Rate When Idle” and 48kHz idle sampling rate. The settings that we’ll focus on will involve the ‘Patchbay/Router’ page. We won’t be using the Delta 66’s Monitor Mixer, so we’ll ignore the ‘Monitor Mixer’ page.

4.Open the Delta Control Panel software and click on the Patchbay/Router tab.

5.For the first stereo pair, H/W Out 1/2, click the radio button in that column for “H/W In 1/2.” For the second stereo pair, H/W Out 3/4, click the radio button in that column to “H/W In 3/4.” Using these settings for the Patchbay/Router page connects each hardware input directly to a hardware output. These settings will allow us to monitor the inputs to the Delta 66 (vocals and guitar) while we are recording.

6.Minimize the Delta Control Panel to the Windows taskbar.

34