InSinkErator H778, C1300 owner manual Troubleshooting

Page 9

TROUBLESHOOTING

PROBLEM

POSSIBLE CAUSE

WHAT TO DO

Water and steam spits

• Unit is boiling.

• Depress faucet lever to release some water from

forcefully from spout

May be normal during initial setup.

the tank.

without turning on the

• Adjust water temperature using dial on tank front.

 

dispenser faucet.

 

 

Remember that at higher altitudes, water boils

 

 

 

 

at lower temperatures.

 

 

 

Water is not hot

• The unit may not be plugged in.

• Make sure the unit is connected to a properly grounded

 

• The electric outlet is inoperative.

electric outlet.

 

• Make sure the circuit breaker or fuses are

 

 

 

 

functioning properly.

 

 

• Check that the outlet is not switched off.

 

 

 

Water is too hot

• Thermostat is not adjusted to

• Adjust the thermostat slowly, then depress or twist faucet handle

or not hot enough

your needs.

for 20 seconds to bring in fresh water to be heated at the new

 

 

setting. Allow 5-7 minutes for water to reach new temperature.

 

 

 

Water comes out the

• Outlet tube is blocked.

• Check that outlet tube is not kinked, twisted or pinched.

vent instead of spout

 

• Unscrew spout end piece and clean out any debris.

 

 

 

 

 

Water is dripping from

• The expansion chamber isn’t draining

• Unplug the unit. If the dripping doesn’t stop after a few

the spout/vent

properly due to low water pressure.

minutes, check the supply valve to ensure that is fully

intermittently

• The spout is blocked.

open and there are no obstructions in the water line

 

reducing the pressure below 30 psi (i.e., a poorly mounted

 

 

 

 

saddle valve, a clogged water filter, or a partially opened

 

 

shut-off valve).

 

 

• Unscrew spout end piece and clean out any debris.

 

 

 

Water is dripping

• Debris in the water line may be

• Unscrew spout end piece and clean out any debris.

from the spout/vent

in the faucet valve seat causing a

• Depress or twist lever 7-10 times to flush faucet & lines.

constantly

slow water leak.

 

Divided stream

• Debris in the faucet lines.

• Unscrew spout end piece and clean out any debris.

If you are still experiencing trouble,

visit www.insinkerator.com or call 1-800-845-8345.

An instant hot water dispenser, like any water heater, has a limited life and will eventually fail. To avoid possible property damage, this instant hot water dispenser should be regularly examined for leakage and replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used in those applications where any leakage could cause property damage.

9

Image 9
Contents Installation, Care & Use This Package What YOU should Know Before YOU BeginRubber O-Ring Hex Nut Hex Tool ScrewsPreparation Do not modify the plug provided with the applianceC1300 Straighten the copper tubing Installing the Faucet C1300Unpack dispenser components On a firm, flat surface, carefullyInstalling the Faucet H778 Mounting the Tank Connecting Faucet to TankFinal Water Connection Fill Tank & then Connect PowerTurn on the cold water supply Independently if applicableNew setting Warranty InformationDisconnect power from unit Care and USETroubleshooting Manual del usuario Las partes internas del tanque provocan un traqueteo normal Dispensador de agua caliente instantáneaEléctrica PreparaciónDesempaque los componentes Instalación DEL Grifo C1300Del surtidor Enderece con cuidado el tubo de cobreDesempaque los componentes del Instalación DEL Grifo H778Dispensador ArandelaConexión DEL Grifo EN EL Tanque Montaje DEL TanqueHaga orificios guía de 1/8 0.3 cm en las marcas El tanque debeLlene EL Tanque Y Enseguida Enchúfelo Conexión Final DEL AguaEnchufe el tanque de agua caliente Con su agente autorizado de servicio In-Sink-EratorInformación Sobre LA Garantía Mantenimiento Y USOCalentarse a la nueva temperatura La temperatura establecida de fábrica esSin abrir la manija del Identificación Y Solución DE ProblemasPosiblemente la unidad no está El tubo de salida está bloqueadoManuel du propriétaire Joint torique Écrou hex Dans CET EmballageOutil hex En caoutchouc Prolongation Rondelle De 4 po Garniture de fibrePréparation Déballez les composantes du Installation DU Robinet C1300Distributeur Sur une surface plane et fermeInstallation DU Robinet H778 Raccordement DU Robinet AU Réservoir Montage DU RéservoirBranchez le réservoir d’eau chaude instantanée Connexion Finale DE L’EAURenseignements SUR LA Garantie Soins ET UtilisationDébranchez le courant à l’appareil Fermez le distributeur à la soupapeDiagnostics 43770

H778, C1300 specifications

The InSinkErator C1300 and H778 are innovative food waste disposal systems that revolutionize kitchen efficiency and sustainability. Designed with advanced technology and user-friendly features, these devices cater to modern homeowners seeking both convenience and ecological responsibility.

The C1300 model is renowned for its compact design that makes it suitable for various kitchen layouts, especially where space may be limited. Its powerful 1 HP motor ensures fast and efficient grinding of food scraps, giving users robust performance without occupying too much space under the sink. The C1300 employs a multi-grind technology that breaks down what could be tough waste, such as fibrous vegetables and small bones, into tiny particles, easily facilitating drain disposal.

The H778, on the other hand, caters particularly to those looking for enhanced performance and versatility. It features a higher horsepower motor, providing an even finer grind and improved waste management capabilities. This model is ideal for households that deal with larger quantities of food waste, making it a perfect fit for busy kitchens and families. The H778 includes a noise-reduction technology that diminishes operational sound, ensuring that your kitchen remains a peaceful environment even during use.

Both models are designed with a stainless-steel grind chamber and components that offer durability and resistance to corrosion. This not only prolongs the lifespan of the units but also ensures that they perform efficiently with reduced maintenance needs over time. Safety is another priority, with features such as a magnetic safety switch that prevents operation when the unit is not properly assembled.

Furthermore, installation is designed to be hassle-free, generally compatible with standard sink configurations and easily integrated into existing plumbing. Many users appreciate the inclusion of an easy-to-use user manual, making it accessible for DIY installations.

In conclusion, the InSinkErator C1300 and H778 embody the perfect blend of efficiency, modern technology, and user-friendly design that aligns with sustainable living practices. These disposals not only tackle kitchen waste management effectively but also contribute to a cleaner environment by reducing landfill waste. As more people embrace eco-conscious living, devices like these stand out as vital kitchen appliances, promoting hygiene and responsible waste disposal. With advanced features and impressive characteristics, the C1300 and H778 represent leading innovations in food waste disposal solutions.