JVC KT-SR1000 manual How S-Seek function works, To delete or deactivate the PDT for S-Seek

Press CHANNEL 5 / ∞ (or CH + / –) to select unnecessary information (PDT), then press

SELECT.

It will be replaced with the new information.

•Cancel: Not to store a new information. The original screen will be resumed.

How S-Seek function works

Each time JVC PnP is turned on, it automatically searches the incoming signal to determine if a match exists between the signal and the PDTs stored in memory (except the ones with “S-Seek” set to “Off”: see the next page).

•If one or more matches are found, “S-Seek Alert” appears for a while, and a beep tone sounds. Play of the current selection will continue until a new selection is made.

Then the S-Seek Alert List screen which displays the current matches appears.

•Press CHANNEL 5 / ∞ (or CH + / –) to select the Artist/Song Title on the S-Seek Alert List screen, then press SELECT.

Note: If no operation is done for about 10 seconds, JVC PnP automatically exits from the S-Seek Alert List screen.

To delete or deactivate the PDT for S-Seek

1. Press and hold MEMO for about 3 seconds.

The most newly stored information appears on the display.

To be continued...