Invacare 1900S manual Mounting the Battery Charger, Disinfecting the Lift

Page 13

SECTION 2—OPERATING THE BATH LIFT

6.After ten minutes, rinse the seat surface, safety strap, shoulder strap, arm rests, and any other non‐electronic surface with the shower wand of the bath. Refer to the individual bathing unit’s owner’s manual for using the shower wand.

CAUTION

DO NOT spray the push handles, scale, or hand pendant with water. Sprayed water may damage the electronic components of the lift.

7.Lightly wipe the push handles, scale, and hand pendant with a damp cloth.

8.Dry all surfaces with a clean towel.

9.Remove the bath lift from the tub. Reverse STEPS 13 to 16 in Transferring into/out of the Bathing Unit on page 9.

DETAIL “A” - NON ELECTRONIC SURFACES

Arm Rests

Seat

Safety Strap

Surface

NOTE: Shoulder

Strap not shown.

Base

DETAIL “B” - ELECTRONIC SURFACES

Hand

Scale

Pendant

 

Push

Handles

FIGURE 2.7 Disinfecting the Lift

Mounting the Battery Charger

NOTE: For this procedure, refer to FIGURE 2.8.

NOTE: Refer to your local regulations concerning proper mounting procedures.

1.Place the battery charger with mounting bracket on the wall at the desired position.

2.With a pencil, mark the middle hole position.

3.Measure down 6½ inches from the pencil mark and drill one mounting hole.

4.Install the bottom mounting screw until there is an approximate 1/8‐inch gap between the screw head and the wall.

5.Install the battery charger with mounting bracket onto the bottom mounting screw.

6.Drill the remaining two mounting holes.

7.Install the two remaining mounting screws through the mounting bracket and into the wall. Tighten securely.

8.Plug the battery charger into the wall electrical outlet.

NOTE: The On LED should illuminate.

Part No. 1148113

13

1900/1900S Bath Lift

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 1900/1900S Bath Lift Accessories Warning Table of Contents Meaning Special NotesLabel Location Bath Lift 1900/1900S Typical Product ParametersOperating the Lift General GuidelinesLifting/Transferring Electrical Grounding Instructions Performing MaintenancePinch Points Transferring into/out of the Bathing Unit Operating the Bath LiftTransferring into/out of the Bathing Unit Raising/Lowering the Bath Lift Using the Scale Model 1900S onlyEmergency Stop Disinfecting the Lift Emergency LoweringDisinfecting the Lift Mounting the Battery ChargerMounting the Battery Charger Charging the BatteryInstalling/Removing the Shoulder Strap Removing/Installing the Safety Strap12 Using the Shoulder Strap Using the Shoulder StrapSafety Inspection Checklists Maintenance and TroubleshootingInspect/Adjust Initially and Monthly Cleaning the Lift Care and Maintenance of Bath LiftDetecting Wear and Damage Adjusting Arm Angle and Tension Maintenance ProceduresInspecting/Tightening the Seat Inspecting and Adjusting the Lift ColumnChanging the Scale Battery Model 1900S only Calibrate the 1900 Scale Calibrate the 1900 ScaleSymptoms Faults Solution TroubleshootingUSA Limited Warranty

1900S, 1900 specifications

Invacare is a leading manufacturer of medical equipment and aids for daily living, with the Invacare 1900 and 1900S being two notable models in their lineup of patient lifting solutions. Designed for efficiency and comfort, these models cater to the needs of both healthcare providers and patients.

One of the standout features of the Invacare 1900 series is its exceptional lifting capacity. With a solid construction, the 1900 model can support weights of up to 400 pounds, making it suitable for a wide range of individuals. The 1900S variant enhances this functionality with an innovative spreader bar, allowing for versatile positioning and improved comfort during lifts.

The 1900 series incorporates advanced technologies to facilitate safe and efficient patient transfers. The hydraulic lift system is operated manually via a foot pedal, enabling caregivers to operate the lifter without straining their back or arms. This design promotes ergonomic practices, reducing the risk of injury for caregivers while ensuring patients feel secure during the lift.

Another key characteristic of the Invacare 1900 and 1900S is their maneuverability. They are equipped with swivel casters that provide smooth movement in tight spaces, allowing caregivers to navigate through doorways and around furniture easily. The base of the lift is adjustable, offering the flexibility to accommodate various situations, whether lifting from a bed, wheelchair, or floor.

Both models feature a simple yet robust control mechanism that allows caregivers to operate the lift system effortlessly. The lifting arm can be adjusted to accommodate different patient heights, ensuring a customized and comfortable fit for each individual. Safety is paramount, and the Invacare 1900 series is designed with stability in mind, ensuring peace of mind during use.

Additionally, the durability of the materials used in the construction of the Invacare 1900 and 1900S ensures long-term reliability. These lifts are built to withstand the rigors of daily use in both home and healthcare settings, making them a wise investment.

In summary, the Invacare 1900 and 1900S patient lifts embody the perfect blend of functionality, safety, and ease of use. With their impressive lifting capabilities, advanced ergonomic design, and user-friendly features, they stand out as essential tools in the care of individuals with mobility challenges. These models not only improve the quality of life for patients but also support caregivers in providing safer, more efficient care.
Top Page Image Contents