HoMedics BRT-150 Special Warnings, Botanical Solution Warnings, Maintenance, Remove Cone

SPECIAL WARNINGS

•If you have any concerns regarding your health, consult your doctor before using bre¯the.

•This appliance is designed for personal, non-professional use only. This appliance should be used only for personal, non-professional uses.

•DO NOT mix solutions. Use only one scent at a time.

•DO NOT over-fill or under-fill the bowl. The Maximum and Minimum fill lines can be found on the outside of the bowl. See Fig. 1 illustration on page 4.

BOTANICAL SOLUTION WARNINGS

CAUTION: Eye Irritant. Keep out of reach of children and pets. This product is not a toy and solution is not intended for human consumption. Contact with enclosed solution may cause irritation. Wash hands thoroughly after handling.

•FIRST AID: If eye contact occurs, rinse immediately with plenty of water for 10 minutes. If ingestion occurs, drink plenty of water. Do not induce vomiting. If irritation persists, seek medical attention.

•If any of the solution is spilled on the floor, use a damp cloth to clean area to avoid slipping.

•Discontinue if allergic reaction is experienced.

•Solutions may stain.

MAINTENANCE

•Always disconnect main cord from electrical outlet before removing top cover or whenever the appliance is not in use.

•It is recommended to change the water every 24 hours.

•If top cover needs to be cleaned, use a damp cloth and wipe gently.

•Do not submerge top cover in water or wash under running water.

•To clean bowl, empty water and use a mild dish detergent to clean. Rinse fully with clean water and dry unit before next use.

(Not dishwasher safe)

•Do not use any chemicals or abrasive scrubs to clean the unit.

•Clean inner cone once per month.

T O REMOVE CONE:

1.Hold disk still with one hand while rotating cone counter-clockwise with other to unlock. (Fig.3)

2.Gently pull cone outward to remove. (Fig.4)

3.Wipe cone and disk with a damp cloth. Do not submerge top cover in water. The inside of the top cover can be cleaned with a damp cloth.

T O REATTACH CONE:

1.Hold disk still with one hand.

2.Align the four locking tabs, located at the base of the cone, with the four notches located on the disk. (Fig.5)

3.Rotate cone clockwise to lock in place. (Fig.6)

•When storing your bre¯the unit, unplug product from electrical outlet, empty the water, and store in a dry, cool place.

•Keep water at an optimum level to avoid shortening the life of the motor.

cone

disk

Fig.3

Fig.4

locking tabs

notches

Fig.5

Fig.6

6 7