Hunter Fan 52080, 52087, 52086, 52090, 52085, 52089, 52081, 52082 Troubleshooting, Fan doesn’t work

Page 15

Troubleshooting

www.HunterFan.com

1.888.830.1326

Fan doesn’t work

Make sure power switch is on.

Pull the pull chain to make sure it is on.

Push the motor reversing switch firmly left or right to ensure that it is engaged.

Check the circuit breaker to ensure the power is turned on.

Make sure the blades spin freely.

Turn off power from the circuit breaker, then loosen the canopy and check all the connections according to the wiring diagram on page 9.

Check the plug connection in the switch housing.

Excessive wobbling

Make sure that the blades are properly installed on the blade iron posts.

Turn the power off, support the fan carefully, and check that the hanger ball is properly seated.

Use the provided balancing kit and instructions to balance the fan.

Noisy Operation

Make sure that the blades are properly installed on the blade iron posts.

Check to see if any of the blades are cracked. If so, replace all of the blades.

Lights dim when turned on or do not turn on at all.

Make sure the wattage of the light bulbs installed matches the specifications on the light sockets.

15

M0008-01 • 04/14/14 • © Hunter Fan Company

Image 15
Contents Table of Contents What to Expect with Your Installation Tools Needed Mounting Options Ceiling Bracket OFFDownrod Steps 1-5 to remove standard downrod pipeSteps 6-10 to reassemble with new pipe Hand Tighten Do not Pick the FAN UP by Wiring Holes CanopyBlades Blade Holes Iron PostFlared Tops Light Kit Switch Housing ScrewNotch Switch Housing Screw Switch housing with the upper switchFinial MetalPlate GlobeMaintenance & Cleaning Fan doesn’t work Troubleshooting