Hunter Fan 41081-01 Assembling and Hanging the Fan, Holes in the top of the fan

			3 • Assembling and Hanging the Fan
Step 3-2	Long	Short		3-1. Remove the blade mounting screws and rubber shipping bumpers
				from the motor.
	Mounting
		Mounting		3-2. Assemble the blade ramp, blade, and blade bracket as shown.
	Screw	Screw
	Blade Bracket			Note: The blades are two-sided. Select which side you would like to
				see and install it face-down.
Blade
				3-3. Align the holes in the ramp, blade, and blade bracket with the
				holes in the top of the fan.
				3-4. Use the 1 1/4” long mounting screws to attach the taller end of
				the blade assembly to the fan, and the 7/8” short mounting screws
				to attach the shorter end of the blade assembly to the fan. Tighten
				all screws securely.
	Ramp			3-5. Leaving the backing on one side of the dots, place the adhesive
				dots onto the back of the decorative decal (the side without
				printing).
Step 3-5				Note: If you have a textured ceiling, you may need to smooth a
				surface for the dots to adhere, or purchase a thicker adhesive.
				3-6. Rest the decorative decal over the motor shaft, with the printed
				side down.
				Long
				Mounting
				Screw
Adhesive				(1 1/4”)
Dot with				Short Mounting
Backing	Decal
				Screw (7/8”)

Printed Side (do not install adhesive dots on this side)

6

41081-01 • 08/04/09 • Hunter Fan Company