Halogen Lights, Carrying a Load, FAN Speed

	Operation
	HALOGEN LIGHTS
	HALOGEN LIGHTS		[b]
	1. Each light has its own switch [a].		[b]
	1. Each light has its own switch [a].

2.Push once to turn the lamp on. Push again to turn the light off.

3.150 watt Bulbs are included.

•To replace bulbs.:

i.Unplug unit and make sure lights cool down.

ii.Remove the wing nut [b] at the

top of the back of the light.

[a]

iii.Carefully let the cover hinge down so as not to break the

lens.		Warning
iv. Re-lamp with Type T-3 150 watt		Always hold the top handle when
iv. Re-lamp with Type T-3 150 watt		Always hold the top handle when
bulb or smalller.		adjusting light direction due to
v. Reverse instructions to close		heat generated from light.
unit.
unit.

CARRYING A LOAD

1.The power plug must be removed from the power socket when carrying a load.

2.Always carry a load with the fan assembly locked in the lowest position (load carrying position).

3.This unit has been tested to carry a maximum capacity of 200 lbs.

4.For taller loads, the fan can be tilted 90 or 180 degrees to reduce load interference with the fan.

1.Use speed control rotary knob to control the fans 3 speeds: High, Medium, and Low.

44805

[8]

10/23/2008