Hunter Fan 42656-01 Hanging and Wiring the Fan, Single Switch Wiring, Dual Switch Wiring

4 • Hanging and Wiring the Fan

4-1. Raise the fan and align the slots in the canopy with the hooks on the ceiling plate.

Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks.

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes.

4-2. Make sure the power to the outlet box and associated wall switch location is still OFF.

To connect the wires, hold the bare metal leads together and place a wire connector over them, then twist the wire connector clockwise until tight.

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

Wire Connector

Single Switch Wiring

Single Switch Wiring:

If you want to, you can control both fan and light with one switch. To do so connect the wires as follows:

•The bare or green ground wire from the ceiling to the green ground wire from the ceiling plate and the green ground wire from the fan

•The white wire from the ceiling to the white wire from the fan

•The black wire from the ceiling to the black and the black/white wire from the fan

Dual Switch Wiring:

•The bare or green ground wire from the ceiling to the green ground wire from the pipe ball assembly

•The white wire from the ceiling to the white wire from the fan

•The black wire from the ceiling to the black wire from the fan

•The black/white wire from the fan to the wire for the wall switch

4-3. Push all wires and wire connectors into the outlet box.

Dual Switch Wiring

7

42656-01 • 08/14/09 • Hunter Fan Company