Hunter Fan 42008-01 manual Assembling and Hanging the Fan

3 • Assembling and Hanging the Fan

Standard	Label
Mounting
Washer
Step 3-1	Canopy
Steps 3-2 – 3-5

You can assemble your fan for standard or angle mounting as shown in steps 3-1 – 3-7.

3-1. Remove the label from the standard mounting washer inside the canopy. Leave the washer in place.

3-2. To assemble the fan to hang down from a flat or angled ceiling, insert the downrod through the canopy.

3-3. Feed the wires from the fan through the downrod.

3-4. Screw the downrod into the fan assembly.

3-5. Using the provided allen wrench, loosen the allen head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with the allen wrench.

CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from

6

Downrod

Canopy (with Washer)

Hanger Pipe

Sleeve

unscrewing. Once assembled, do not remove the downrod.

WARNING: Do not carry or lift fan by canopy.

3-6. Raise the fan and place the ball into the hanger bracket.

3-7. Align the notch on the ball with the indent in the hanger bracket. (Rotate the fan until you hear the notch pop into place.)

WARNING: Fan may fall if not assembled as directed in these installation instructions.

Set Screw	Adapter
	Cover

Indent

Steps 3-6 – 3-7

Hunter Fan Company 42008-01 • 12/07/05