SlumberTroubleshooting
SLUMBER TIME
The clock radio has a
Setting the slumber time
The period which you continue to listen to the radio before you fall asleep is called the slumber time.
1.Set the RADIO switch to OFF.
2.Set your slumber time by pressing on the SLUMBER button.
–If you press the SLUMBER button once, 59 will appear on the display indicating that you have a slumber time of 59 minutes.
–If you keep the SLUMBER button pressed, the display will slowly begin to count down from 59 to 00 minutes. Release the button as soon as the required slumber time is reached.
Cancelling the slumber time
You can switch off the radio before the slumber time has elapsed.
1.Press the SLUMBER OFF/REPEAT ALARM button to cancel the slumber function.
Note:
–The slumber function does not affect the alarm setting(s).
–If you have an alarm set in the radio mode, make sure you have adjusted the volume loud enough to wake you up before you set the slumber time.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Problem
–Possible Cause
• Remedy
No sound
–Volume not adjusted.
• Adjust the VOLUME.
–Mains lead not securely connected.
• Connect the mains lead properly.
MW/LW broadcast cannot be received
– Set too close to electrical equipment e.g. TVs, computer, fluorescent lamps.
•Move the clock radio away from electrical equipment.
Intermittent crackling sound during FM reception
– Weak signal.
• Adjust the pigtail aerial.
The alarm does not function
– The alarm is not set.
•Set the alarm time and the alarm switch to BUZ or RAD.
–Volume too low for radio.
• Increase the volume.
This set complies with the radio interference requirements of the European Community.
The model and production number are located on the rear of the set.
English
9
