Hunter Fan 42405-01 warranty Installing the Ceiling Plate, Step Steps 2-3

Page 5

CAUTION: To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.

2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. e pilot holes should be 9/64” in diameter.

2-2. Your fan comes with two neoprene noise isolators (“Isolators”). Position the isolators between the ceiling plate and ceiling by inserting the raised areas on each isolator into the holes in the ceiling plate.

2-3. read the lead wires from the outlet box down through the hole in the middle of the ceiling plate.

2-4. Place a flat washer on each of the two 3” wood screws.

2-5. Align the slotted holes in the ceiling plate with the pilot holes you drilled in the wood support structure. For proper alignment use slotted holes directly across from each other.

Note: e isolators should be flush against the ceiling.

2-6. Pass the screws through the slotted holes in the ceiling plate into the pilot holes you drilled.

Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten.

Flat Washer

3” Wood Screw

2 • Installing the Ceiling Plate

Ceiling

Plate

Step 2-2

5

Steps 2-32-6

Towards

Ceiling Peak

For Angled Ceilings: Be sure to orient the ceiling plate so that the two tabs are pointing towards the ceiling peak.

42405-01 • 01/20/06

Hunter Fan Company

Image 5
Contents For Your Records and Warranty Assistance Hunter Fan Company Table of ContentsWelcome Angle Mounting recommended for a vaulted or angled ceiling Installer’s Choice and Optional AccessoriesStandard Mounting hangs from Getting Ready Installing Multiple Fans?Step Steps 2-3 Installing the Ceiling PlateFor Standard or Angled Mounting Assembling and Hanging the FanFor Low Profile Mounting Steps 3-2Single Switch Wiring Wiring the FanStep Installing the CanopySteps 6-1 Assembling the BladesDetail Steps 7-5 Steps 7-1Cold weather , use upward Operating and Cleaning Your Ceiling FanTo Change Airflow Direction Problem Nothing happens fan does not move TroubleshootingProblem Noisy operation Problem Excessive wobbling