Setting the Remote Transmitter and Receiver

4 • Setting the Remote Transmitter and Receiver

Setting DIP switches

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.

The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the transmitter are in the battery compartment.

4-1. IMPORTANT! Before you change the DIP switch settings, make sure the battery is not connected to the transmitter.

Change the position of the DIP switches in the remote transmitter and the receiver. Make sure that the DIP switches match in

the remote receiver and transmitter. If they don’t match, the transmitter will not function.

4-2. There is a toggle switch beside the DIP switches on the transmitter. Move the toggle switch toward the side that reads “CFL” if you are going to operate the fan with CFL bulbs. Move the switch to the “INC” side if you are going to use incandescent bulbs.

4-3. Install the included 9-volt battery into the transmitter.

CAUTION: The remote control device complies with part 15 of the FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Use only the Hunter Fan speed control supplied with this fan.

4-4. Raise the fan and align the slots in the canopy with the hooks on the ceiling plate.

Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks.

Receiver DIP switches

Transmitter DIP switches

Example DIP Switch Settings
Receiver 1	Receiver 2
DIP Switches	DIP Switches
Set to 0111	Set to 0100
Transmitter 1	Transmitter 2
DIP Switches	DIP Switches
Set to 0111	Set to 0100

45062-01 • 07/01/09 • Hunter Fan Company