Hunter Fan 45006-0109 warranty Wiring the Fan, Dual Switch Wiring, Single Switch Wiring

4 •Wiring the Fan	Wiring
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
All wiring must be in accordance with national and local electrical
qualified electrician.	&
	Bracket
4-1. Before attempting installation, make sure the power is still off.
Wall switches are not included. Select an acceptable general-use switch
in accordance with national and local electrical codes.	Install
4-2. To connect the wires, hold the bare metal leads together and place
a wire nut over them, then twist clockwise until tight. For all these
connections use the wire connectors provided.
4-3. Connect the bare or green ground wire (grounded) from the
ceiling to the green ground wire (grounded) from the ceiling plate
and the green ground wire from the fan.
4-4. Connect the white wire (ungrounded) from the ceiling to the
white wire (ungrounded) from the fan.
4-5. Connect the remaining wires as follows:	Wire
Dual Switch Wiring:	Connector

•The black wire (ungrounded) from the ceiling to the black wire

(ungrounded) from the fan

•The black/white wire (ungrounded) from the fan to the wire

(ungrounded) for the wall switch

Single Switch Wiring:

•The black wire (ungrounded) from the ceiling to the black

(ungrounded) and the black/white wire (ungrounded) from the fan

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

4-6. Turn the wire connectors upward and push them carefully back through the ceiling plate into the outlet box.

4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.

8

45006-01 • 09/26/07 • Hunter Fan Company