Hunter Fan 53095, 53090, 53094, 53091 operation manual Hand Tighten

Page 8

Downrod (continued)

www.HunterFan.com

1.888.830.1326

					E





					K	E
					K	P
							!

Remove the pre-installed

setscrew so that the downrod

can be inserted.

Hand tighten the downrod (at least 4-5 full turns) until it stops.

8”

The wires can be cut, but leave at least 8” extending from the top of the downrod.

Tighten the setscrew with pliers. DO NOT

HAND TIGHTEN.

3/8”

If the setscrew is not tightened securely, the fan may fall.

8

M0043-01 • 10/22/13 • © Hunter Fan Company

Image 8

Contents Table of Contents ? ?What to Expect with Your Installation Tools Needed Mounting Options For angled ceilings, point Opening toward peak Ceiling BracketMake sure all four 4 bumpers Are still attached Preparation Downrod Hand Tighten Put the wires and downrod through FanWiring Canopy HolesBlades Switch Housing Feed the wire plug through the centerThrough the hole in the light kit Light KitPlugs from the upper and lower Chain Install a light bulb in each socketKeeper Maintenance & Cleaning Customer serviceTroubleshooting Fan doesn’t work