Hunter Fan 90434, 90435 owner manual Operation, Off / Speed Selection

Page 11

Operation

Off / Speed Selection

To turn the fan on and off / control the speed. Turn the speed knob on the top of the motor to the porper setting. Figure 19.

Oscillation

To allow the fan to oscillate, push the Knob beside the fan speed control down. Pull up on the knob if oscillation is not desired. Figure 20.

Adjustment

To adjust the angle the fan is blowing.

1.Loosen the adjustment knob under the Fan Motor

2.Adjust the fan to the angle desired and retighten the knob to secure the fan at that angle. Figure 21.

When adjusting the height of the fan, always grip the pole above the adjustment knob firmly to prevent the telescoping pole from collapsing.

Low

Medium

OffHigh

Figure 19.

Figure 20.

Figure 21.

©2010 Hunter Fan Co.

11

44086-01 20101102

Image 11
Contents Oscillating Table of Contents Introduction Safety and WarningsPage Grounding Line Cord Safety TipsFused Plug Fuse ReplacementUnpacking Base AssemblyMotor Assembly Grill Assembly 11Front Grill Screw Grill Ring Cord Cord Clip Notch Off / Speed Selection OperationIf servicing is needed MaintenanceTechnical Support WarrantyHunter Fan Co 44086-01 Products