Hunter Fan 90435, 90434 owner manual Motor Assembly

Page 8

Motor Assembly

1.Grasp the Telescope Pole firmly and twist the Adjustment Knob Counter Clockwise to loosen. Figure 7.

2.Raise the Inner Pole and tighten the Adjustment Knob by twisting Clockwise until secure.

3.Remove the Motor Knob(7), Motor Bolt(6), and Tilt Adjustment Knob(8). Loosen the screw above the Motor Knob(7).

4.Set the Motor(5) on top of the Pole(3), Figure 8., and Secure using the Motor Bolt(6) and Knob(7). Retighten the screw above the motor knob in the slot to secure motor. Figure 9.

Note: The Motor Bolt has a square cut on the inside of the head, ensure this fits securely into the square hole in the Pole. Do not overtighten the Motor Knob, as this could make it difficult to tilt the motor later.

After securing the motor(5), Screw in the Tilt Adjustment Knob(8) securely. Figure 10. This Knob allows you to adjust the fans angle.

Figure 7.

(5) Motor

(8) Tilt

ScrewAdjustment

Knob

 

(6) Motor

(7) Motor

Bolt

Knob

(3) Telescope Pole

Figure 8.

(7) Motor

Knob

(6) Motor

Bolt

Figure 9.

(8)Tilt Adjustment Knob

Figure 10.

©2010 Hunter Fan Co.

8

44086-01 20101102

Image 8
Contents Oscillating Table of Contents Safety and Warnings IntroductionPage Line Cord Safety Tips GroundingFuse Replacement Fused PlugBase Assembly UnpackingMotor Assembly Grill Assembly 11Front Grill Screw Grill Ring Cord Cord Clip Notch Operation Off / Speed SelectionMaintenance If servicing is neededWarranty Technical SupportHunter Fan Co 44086-01 Products