Hunter Fan Illumi-Heat owner manual Transmitter Terminals Connector

P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t

U n i t s i n Yo u r H o m e

If you are going to install more than one Illumi-Heat in your home, then you will need to assign each unit a its own unique Transmitter / Receiver Code.

1) Looking at the fixture from its top, locate the Receiver, as shown in Figure 1.

Top View of Fixture

(Bracket cut away

for clarity.)

Receiver

ON DIP

1 2 3 4

Figure 1 - Receiver

2)On the Receiver you will see the four switches that you will use to set the code for the Transmitter and the Receiver. See Figure 2.

Switches	ON DIP
NOTE - All Switches are
	ON DIP
shown in the ON position	1 2 3 4
	1 2 3 4

Figure 2 - Receiver Code Switches

P R E - I N S TA L L AT I O N f o r M u l i t p l e I l l u m i - H e a t

U n i t s i n Yo u r H o m e

3)Configure the Receiver Switches to your desired code. Make a note of which Receiver Switches you turned On and turned Off. NOTE: Make certain each Receiver is assigned a different code.

4)Remove the Transmitter Battery Compartment door as shown in Figure 3.

Transmitter Battery

Compartment Door

Figure 3 - Remove Transmitter Battery Compartment Door

5)For every Receiver Code Switch you turned Off, use a pair of needle-nosed pliers to carefully remove its corresponding Connector from the Transmitter Terminals. See Figure 4. For instance, if you turned Off Receiver Switches 1 and 3, then you would remove Connectors 1 and 3 from the Transmitter.

Transmitter Terminals	1	2	3	4
Connector

Figure 4 - Transmitter Terminals and Connector

43533-01 05/28/2008 4 5 43533-01 05/28/2008