![](/images/new-backgrounds/1266203/266203149x1.webp)
Installation procedures 75
Connecting the ISDN BRI terminals ISDN BRI terminals are connected to DSLs using modular cables not longer than 10 m (33 ft) with
All terminals must be compatible with the system and comply with one of the following protocols for ISDN BRI terminals:
•ETSI
•INS
•NUMERIS
•ANSI standards
Contact your Nortel Networks representative for the latest list of compatible terminals.
To connect 1TR6 terminals, an ETSI
S/T interface specification
The S/T interface uses an
Table 17 "S/T interface connector specification" (page 75) shows the connector pin assignment for the jack and the plug. It also shows the signal names for each interface pin at the SILC and at the terminal.
Table 17
S/T interface connector specification
| RJ45 jack | SILC |
Pin number | pin signal name | signal name |
|
|
|
1 | Power Source 3 | No connection |
2 | Power Source 3 | No connection |
3 | TX + | RX + |
4 | RX + | TX + |
5 | RX - | TX - |
6 | TX - | RX - |
7 | Power Sink 2 | No connection |
8 | Power Sink 2 (+) | No connection |
|
|
|
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
Release 5.0 20 June 2007
Copyright ©