![](/images/new-backgrounds/1266203/266203111x1.webp)
56Configuring ISDN BRI hardware
Configure DSL for ISDN BRI trunking in LD 27. Refer to Table 14 "Correct responses to LOOP and MISP prompts in LD 27" (page 56) for the correct response to the MISP prompt.
Table 14
Correct responses to LOOP and MISP prompts in LD 27
|
| LOOP | MISP | ||
|
|
|
|
|
|
| Main | 1 | – 9 | 1 | – 9 |
|
|
|
|
|
|
| Expansion 1 | 11 | – 19 | 11 | – 19 |
|
|
|
|
|
|
Cabinet Systems | Expansion 2 | 21 | – 29 | 21 | – 29 |
|
|
|
|
|
|
| Expansion 3 | 31 | – 39 | 31 | – 39 |
|
|
|
|
|
|
| Expansion 4 | 41 | – 49 | 41 | – 49 |
|
|
|
|
|
|
| MG 1000S 1 | 11 | – 14 | 11 | – 14 |
|
|
|
|
|
|
CS 1000S and Chassis | MG 1000S 2 | 21 | – 24 | 21 | – 24 |
Systems | MG 1000S 3 | 31 | – 34 | 31 | – 34 |
|
|
|
|
|
|
| MG 1000S 4 | 41 | – 44 | 41 | – 44 |
|
|
|
|
|
|
Installation procedures
Summary
The following is a summary of the procedures to install and configure ISDN BRI hardware. Collectively, the procedures apply to line, packet data, and trunking applications. Individually, some procedures apply only to line, packet data, or trunking.
Before beginning the procedures, ensure the system is installed and operational. Perform the procedures in the order shown.
Step Action
1Select the card slots. See Procedure 14 "Selecting the card slots" (page 58).
2Remove the MISP, if previously installed. See Procedure 16 "Removing the MISP" (page 60).
3Install the clock controller on the MISP (for trunking applications only). "Installing the clock controller on the MISP (for trunking applications)" (page 60)
4Install the MISP. See Procedure 15 "Installing the MISP" (page 59).
Note 1: A clock controller is only required for ISDN BRI trunk applications. The system supports a single active clock controller (CC). This clock controller can support both a primary and a
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
Release 5.0 20 June 2007
Copyright ©